Configure the Exinda Appliance for VRRP with PBR through the CLI

To use policy-based routing, the interfaces on the Exinda appliancemust be configured with the appropriate settings.

	Note The appliance can be configured either through theExinda Web UIor through the CLI.

1. On the out-of-path Exinda appliance # 1, launch the Exinda Web UI. Show steps...

   1. In the browser address field, type https://Exinda_IP_address.

   2. Enter the appliance User Name and Password. Click Login.

      The Exinda Web UI is displayed.

   3. Ensure you are in Advanced mode.
2. Click Configuration > System > Tools > Console.
3. Type the appliance username and password at the prompts.

   • To enter privileged EXEC (enable) mode, at the prompt type the following command:

     hostname > enable

     The hostname # prompt is displayed.

   • To enter configuration (config) mode, at the prompt type the following commands:

     hostname # configure terminal

     The hostname (config)# prompt is displayed.

4. Remove the BR10 bridge.

   hostname (config)# no bridge BR10 enable

5. Set the IP address and netmask of the out-of-path Exinda appliance #1.

   hostname (config)# interface eth11 ip address 10.10.10.2 /8

6. Identify the interface to be used for policy-based routing.

   hostname (config)# pbr interface eth11

7. Set the IP address of the router.

   hostname (config)# pbr interface ip next-hop 10.10.10.1

8. To set the parameters of eth11, type the following commands:

   hostname (config)# no interface eth11 dhcp

   hostname (config)# interface eth11 display

   hostname (config)# interface eth11 duplex auto

   hostname (config)# interface eth11 mtu 1500

   hostname (config)# no interface eth11 shutdown

   hostname (config)# interface eth11 speed auto

9. To set the VRRP parameters, type the following commands:

   hostname (config)# vrrp interface eth11 delay 1

   hostname (config)# vrrp interface eth11 enable

   hostname (config)# vrrp interface eth11 priority 100

   hostname (config)# vrrp interface eth11 vip 10.10.10.100

   hostname (config)# vrrp interface eth11 vrid 50

10. Repeat these steps on the out-of-path Exinda appliance #2 using the appropriate IP address in Step 5.