How To Guides > Clustering and High Availability > Cluster Interfaces

Cluster Interfaces

Before configuring clustering, the Exinda appliances must be correctly cabled. It is recommended that each appliance in the cluster be connected and configured with a dedicated management port.

In addition, clustering requires a dedicated interface for traffic that is internal to the cluster. Any interface that is not bridged or in use for another role (e.g., Mirror or WCCP) may be used..

The table below lists the suggested cluster interface for each hardware series.

Hardware Series	Cluster Interface
2000/4000 (EOL)	eth1 (with Bridge 0 disabled)
4060/4061	eth2
5000	eth1
6000	eth5 (with Bridge 2 disabled)
6010	eth1
6060	eth2
7000	eth1
8060	eth2
10060	eth2

Where there are two appliances in a cluster, the cluster interfaces may be connected directly to each other with a CAT 5 cross-over cable.
Where there are more than two appliances in a cluster, the interface for each appliance in a cluster must be connected to a single, dedicated switch, such that each appliance can communicate with every other appliance without requiring a route (they must be on the same Layer 2 LAN segment).

	Note Clustering is not available on the 2060 Hardware Series.

Note

Clustering is not available on the 2060 Hardware Series.